Digsnake3

Your own Local Mic-Pre and NS Digital Snake

At the stage:

- Connect 8-32 channel output from mic-pre to Mamba using Hosa DTF (DB25 to Female XLR or DB25 to TRS)
- Connect any line level instrument direct to mamba via DTF cable
- Use Hosa DTM cable to connect the returns from FoH to stage amplifiers/speakers (line level)
- Run one to two CAT-5/6 cable (main and redundant) to FoH

At the FoH:

- Use Hosa DTM (DB25 to Male XLR) to connect the outputs from mamba to your mixing board
- Use Hosa DTF (DB25 to XLR F) to connect any the returns to Stage
- Connect the two CAT-5/6 cable from Stage end

Your own Remote Mic-pre and the Mamba

Connect all audio channels (balanced line level) from the Mic-Pre to the Mamba. Remote
control of the Mic-Pre can be obtained through the following 3 ways:

1. If you have a single control channel cable, you can still use it in the same way by
connecting it directly from the Mic-Pre to the mixing board.

2. If you have an IP based Mic-Pre remote control, it can also be used in the same way by connecting
the Mic-Pre and Mixer directly to the IP Network.

3. Control can be carried over the same CAT5/6 cable as the audio by connecting the control
interface from the Mic-Pre to the Mamba at the stage (interface option required) and the control
interface from the Mixer to the FoH Mamba. Control data from the Mixer will be carried over the
Cat-5/6 along with the audio and will be passed to the Mic-Pre.